Multi Metal Coating – MM30

MM30


Multi Metall Beschichtung - MM30

Extreme corrosion protection

Temperature resistant

Overpaintable

Spot weldable

DIN EN ISO 1461
Description

Multi-metal coating with aluminum-titanium-zinc cathodic long-term corrosion protection. Extremely resistant and very high-quality surface quality after full hardening. Very good adhesion to steel, aluminum, and copper, can be overpainted as a bonding bridge with commercially available 1-component and 2-component paints.

Spot weldable. Resistance over 500 hours at only 15 μm in salt spray test. Use on car bodies, steel frames, steel construction, heating and ventilation construction and industry.

Application

Shake can for at least 3 minutes before use. The substrate must be clean, dry, free of grease and silicone. Remove rust beforehand with FERTAN. For optimum effect, apply a thin layer of M M 30 Spray in 1-2 spraying cycles, spray distance at least 15 – 25 cm. After use, spray over the head of the spray valve. Dust-dry after approx. 5 – 10 min. Touch-proof after approx. 1 hour. Complete hardening after 2-3 days at 20° C in each case. Temperature resistant up to 300° C.

Note

The container is under pressure. Protect against sunlight and do not expose to a temperature above 50°C. Do not puncture or burn, even after use. Do not evaporate on a flame or a glowing object. Keep out of the reach of children. Keep away from heat, open flames, hot surfaces. Do not smoke.

Diese Website verwendet Cookies. Mehr Informationen

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close